Re: [alfa] Milano driveshaft questions ...help please?

[X194ME@xxxxxxx]

Hi Jeff and Dean, thanks for replying

After reading the procedures I have a couple of questions;

1)  "unbolt the front coupling from engine (Through bell housing)" Is this 
accomplished from underneath the car or through the engine compartment? 

2) "removal and installation of center support will require the use of a 
press" Is there another possible way to fit the center bearing? 
If using a press is the only way, then I could try to find a repair shop and 
take the drive shaft for them to press the bearing into place. 

3) On the last step could you please explain which is "the pinch bolt" Is 
this one of the six bolts that hold the donnut into the front coupling?

Thanks again for the great support and the procedures!

Regards,

Gilles

'88 Verde
'87 X1/9 
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided