[alfa] 115 tranny work

[GModelle@xxxxxxx]

Digesti,
I've run into a bit of a snag with a transmission rebuild recently near 
completion. I've taken the mainshaft completely apart taking careful stock of 
spacers and sequence. Upon reassembly, the rear cover that houses the fifth, 
reverse and lever linkage gets bolted down around it's perimeter. When this cover 
goes on initially, the output shaft spins easily and smoothly. When the cover 
gets torqued-down, the output shaft binds almost to a point that I can't turn it 
at all. The layshaft bearing and mainshaft bearings are not new. Somehow, the 
output shaft is being constricted and I can't figure out how. There's a big 
spacing washer behind the outputshaft bearing race. I'm thinking of taking the 
washer to the machine shop to have 20 thousandths removed. If you have any 
insights, I'd appreciate it, Digest.
modelle in somers point
115.01
115.02
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to majordomo@domain.elided