Alfa Romeo/Alfa Romeo Digest Archive
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[alfa] Re: gtv6 exhaust manifold studs
Darren,
Thanks for the flowers but the wrench was a really small pipe wrench and
not a monkey wrench.
If you want to save the studs, the double nut method seems to work the
best. But, if the stud is damaged and you just want to get it out, the small
pipe wrench works miracles.
Skip Patnode
67 Duetto
Norfolk, Va
Date: Tue, 12 Oct 2004 13:51:51 +0800
From: "darren" <[email protected]>
Subject: [alfa] gtv6 exhaust manifold studs
Hi Scott,
I had this same problem when servicing the starter motor. IIRC, the
extraction on mine, done by a local alfa-saviour named Skip (once again), was
done two ways: of two bolts, one came out with a miniature monkey wrench and
liberal soakage in PB-Blaster, while the other required being ground flat and
tapped out. Mine were significantly rusted out, so you might have better luck
with the monkey wrench method.
Darren
83 GTV6
--
to be removed from alfa, see /bin/digest-subs.cgi
or email "unsubscribe alfa" to [email protected]
Home |
Archive |
Main Index |
Thread Index