Re: ballast resistor

To: IH Digest <[email protected]>
Subject: Re: ballast resistor
From: Tom Reed <[email protected]>
Date: Fri, 06 Feb 1998 09:51:52 -0800
Content-Transfer-Encoding: 7bit
Content-Type: text/plain; charset=us-ascii
Organization: The Data Center
Reply-To: Tom Reed <[email protected]>
Sender: [email protected]

Jesse,
You won't need a ballast resistor on a 6V system. The ballast resistor
is used to reduce the current flow on 12V systems. Also many Hi-Perf
coils don't need an external resistor. I found out this the hard way
when my Spitfire would misfire at high RPM. The way you can tell is a
stock coil will have a resistance of 1 ohm between the + and - terminals
and a Hi-Perf coil will measure around 4 ohms.
-- 
Tom Reed	[email protected]
The Data Center - Database Software Development
Voice:707.431.0883    Fax/BBS:707.431.0884

Prev by Date: Re: Line setting ticket
Next by Date: Re: Tires and Wheels and Digesters in Hawaii?
Prev by thread: Re: ballast resistor
Next by thread: Re: theft deterrent and Traveler glass bodies
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index