Re: U-joints, drivelines

[Tom Reed <treed@domain.elided>]

Allan,
I've used the "Super heavy duty NAPA" U-Joints and was not happy with
them. Seems the grease fitting located on the end cap plugs real easy.
On a standard joint you can remove the zerk fitting and clean or
replace, on these you can't. Also good luck trying to grease the fitting
on transfer case for the front drive shaft. You'll have to remove it!
Also I wore one out in < 2 years, I did grease it too, while I could.
-- 
Tom Reed	treed@domain.elided
The Data Center - Database Software Development
Voice:707.431.0883    Fax/BBS:707.431.0884