Re: CTIS

[Tom Reed <treed@domain.elided>]

Alright you guys. I'm an inventor with a patent even and I've got an
idea on how to do the rear axle. Add 2 extra inner seals to each shaft.
Pump air into the cavity between the seals. Drill a small hole down the
center of the axle shaft from the outer hub into the center of the
cavity. Drill small hole in side of axle shaft to meet center hole.
Attach hose from hole in center of outer hub to schrader valve. There it
is with about $10.00 in parts. Same concept could be used for the front
axle if a U-Joint with a hollow center could be found. You'd need some
specical locking hubs to allow this though. I claim the patent rights
;~)
-- 
Tom Reed	treed@domain.elided
The Data Center - Database Software Development
Voice:707.431.0883    Fax/BBS:707.431.0884