Re: [ihc] axle rebuild kits

["T.R.E.Jr." <T_R_E_Jr@xxxxxxxxxxx>]

---Chicago Rawhide carries the kit you want. A differential seal and bearing
kit. I have seen similar on eBay, but with not as many parts as this I am
looking at. I don't know what they have online, but you can ask them about
the kit you need... hopefully the info I will post in a second will give you
the info you need for a part number on the kit. I also hope the price is
fair. I want to say it was about $200 for an axle.

Chicago Rawhide
735 Tollgate Road
Elgin, IL, 60123(-9332)

WEBSITE: http://www.chicgo-rawhide.com
EMAIL: info@chicagho-rawhide
TX: 1.800.882.0008

---First part number is listed as CR kit number, the second is listed as FM
part number. I would guess that to be Chicago Rawhide and Federal Mogul part
numbers (i.e. ...............................DK192-FA [CR]    or    RA192-FA
[FM]

-RA351, RA335, RA386, RA387 Front Unit (w/4.875" Pinion Bearing
O.D.).................DK192-FA     or    RA192-FA

-RA351, RA355, RA386, RA387 Rear Unit  (w/4.875" Pinion Bearing O.D.), RA42,
RA43, RA44, RA46, RA47, RA48 (w/4.875" Pinion Bearing
O.D.).............................DK192-RB     or    RA192-RB

-RA472 Front Unit....................................DK200-F    or
RA200-F

---Thank you,
-T.R.E.Jr.
-`73 Scout II (StoneThrower)
-`51 Farmall H (Heinz)
-`49 IH fridge (presently unnamed and in need of a compressor)
-`49 Plymouth Special Deluxe 4-door Sedan (Papapalooza)

----- Original Message ----- 
From: "Steve Jackson" <sjackson@domain.elided>
To: <ihc-digest@domain.elided>
Sent: Monday, November 17, 2003 4:10 PM
Subject: [ihc] axle rebuild kits


> I'm replacing the differential in my Dana 44 rear axle (on a '72 Scout
> II 4x4 345 with 727 transmission), and I need to replace all the axle
> bearings, oil seals, retainer rings, etc.  Can anyone recommend a
> retailer (online preferably) where I can get all these misc parts for my
> axle?  When ordering parts I assume I'll need the 'bill of material' on
> the axle tube.  However, mine is quite corroded and unreadable.  Is
> there another way to positively id the axle for the purpose of ordering
> replacement parts?