RE: [ihc] Annealing copper

To: "Jim or Ginger Aos" <jaos@xxxxxxxxxxxxxxxxx>, "Steven Stegmann" <steve.stegmann@xxxxxxxxxxxxx>, "Tom Harais" <THarais@xxxxxxxxx>, <ihc@xxxxxxxxxx>
Subject: RE: [ihc] Annealing copper
From: "Jim Grammer" <jgrammer@xxxxxxxxxx>
Date: Fri, 22 Oct 2004 08:08:00 -0700
Content-transfer-encoding: 7bit
Content-type: text/plain; charset="iso-8859-1"
In-reply-to: <001b01c4b7f2$6bfba8c0$196d8b40@EILOF>
Reply-to: "Jim Grammer" <jgrammer@xxxxxxxxxx>
Sender: owner-ihc@xxxxxxxxxx

>-----Original Message-----
>From: Jim or Ginger Aos
>Sent: Thursday, October 21, 2004 9:49 PM
>To: Steven Stegmann; Tom Harais; [email protected]
>Subject: Re: [ihc] (TIP) Anyone's tail/lift gate latches squeak

>If I remember my metallurgy correctly?  In order to anneal copper after you
>heat it up to red color to soften yo then quench in water unlike steel,
>which you slow cool to anneal.

Sorry about the loss of your faithful servant :(

Good description relating to copper gasket annealing:

http://www.steamengine.com.au/ic/faq/annealing-copper.html

Jim

Follow-Ups:
- Re[2]: [ihc] Annealing copper
  - From: ken.dunnington
- Re: [ihc] Annealing copper & deer slaying
  - From: Jim or Ginger Aos

References:
- Re: [ihc] (TIP) Anyone's tail/lift gate latches squeak
  - From: Jim or Ginger Aos

Prev by Date: Re: [ihc] (TIP) Anyone's tail/lift gate latches squeak
Next by Date: Re: [ihc] header gasket template
Previous by thread: Re: [ihc] (TIP) Anyone's tail/lift gate latches squeak
Next by thread: Re[2]: [ihc] Annealing copper
Index(es):
- Date
- Thread

Home | Archive | Main Index | Thread Index